Fitz
Oct 4th, '03, 02:50 PM
I created a Multipower containing two different HKA slots. I set as common modifiers OAF and Reduced END - 0 END. I finished defining the Multipower and set it in the Powers panel.
No problem so far.
Then the auto-validator popped up a message saying that Reduced END wasn't a valid common modifier because HKA doesn't use END.
I thought "Whuh?"
I reopened the multipower and reset REduced END as a common modifier, no problem. It hasn't done it again (yet).
I suspect -- though I don't know for sure -- that the validator scanned the contents of the multipower, found that all of the contents were at 0 END, and so decided that Reduced END wasn't valid as a common modifier for the multipower because none of the contents used END..... though in this case it's because of the original common modifier.
Sound reasonable?
In any case, it seems to be an intermittent error (the worst kind :) )
No problem so far.
Then the auto-validator popped up a message saying that Reduced END wasn't a valid common modifier because HKA doesn't use END.
I thought "Whuh?"
I reopened the multipower and reset REduced END as a common modifier, no problem. It hasn't done it again (yet).
I suspect -- though I don't know for sure -- that the validator scanned the contents of the multipower, found that all of the contents were at 0 END, and so decided that Reduced END wasn't valid as a common modifier for the multipower because none of the contents used END..... though in this case it's because of the original common modifier.
Sound reasonable?
In any case, it seems to be an intermittent error (the worst kind :) )